As I said, these plastic housings are made of stronger better plastic compared to the molded connectors. You can see the individual wires are crimped to the pins and the pins are removable. ![]() Only use cables with press-fit wires, or with crimped wires, where the pins are crimped to wires and then inserted into the plastic housing - the plastic on those connectors is different, more sturdy, harder, resists temperatures better and doesn't flex as much compared to the plastic of those molded sata connectors.Įxample of press fit (not the right technical term but easiest that comes to mind ) : Įach set of 3 pins is in its own "channel" and has a U shape at the end and the cable is "punched down" or pressed into the U shape cutting through the insulation of the cable and squeezing the copper making very strong connection (same principle used in networking with keystone jacks) NEVER use such connectors in things you care about. The only thing that would be off brand are the splitter/adapter.ġ2 HGST 0F27001 that theoretically can use up to 14.1W each. The Molex cables to the PSU are the original one from Cooler Master. When writing a lot of data, you may get up to 2A of current (6-8w is not impossible for a SATA SSD) 2.5A for a few seconds.Ī SSD will consume power only from 5v, usually very little when reading data from SSD. When it spins up, a drive tends to consume a bit more, like 2. The limitation on cables are not the individual connectors, it's the connector that goes into the power supply, there you have around 10A of current.Ī mechanical hard drive consumes under 1A from both 5v and 12v. Molex (old style HDD) is rated at 5A per voltage. SATA connectors are rated at 4.5A per voltage, but if the wires are molded into the housing and not crimped, I wouldn't use them with more than 3A. In that case, we consider the left pin at the FFC/FPC insertion open mouth side as the PIN 1, leaving the option for the end-user to choose from left-to-right or right-to-left.Double check that the pinout if the cables are from another power supply model. But, in some series, the triangle mark may not be there. The triangle mark on the actuator indicates PIN 1.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |